1. Skip to Menu
  2. Skip to Content
  3. Skip to Footer

 

FILLCONTROL Overview
 
Fillcontrol Module 5 en 150724

There is never only a single issue with injcetion molding. Therefore there is never only one solution.
FILLCONTROL consists of different system components which are - depending on the application - used for documenting, monitoring and controlling of the injection molding process depending on the application.

This is always based on real process data measured in the mold. Because good parts are not made with the machine, but only inside the mold. The moment that the melt front passes over a sensor, it is automatically detected by the system. With this information we can determine material viscosity, open and close valve gates, and sequentially control the mold so that flash is prevented.